A2N Kernel Control (Manager) for S8/S8+

# Supported Models # -- G950F -- G950FD -- G950N -- G955F -- G955FD -- G955N # Requirements # -- Time: 45 - 75 min -- Difficult level: very easy step-by-step -- PC / notebook with Win XP or later -- USB cable to connect the phone to your PC / notebook -- USB flash drive or micro-sd-card with an appropriate card-reader -- Android 9 on your phone -- Custom recovery e.g. TWRP* on your phone -- A2N Kernel for Android 9 -- Internet connection for this app to check license (very low data usage) All the needed stuff you will find in my XDA thread or if you buy directly the app then it will redirect you to the proper thread. * By flashing a custom recovery your phone will perform a factory reset. So backup all your data to your external storage like micro-sd-card or USB flash drive. If your phone is very slow or have any issues then this is a good occasion to flash A2N Kernel, this is a win-win situation ! # App Features # # Power -- Charger Control -- Adjust AC/USB-PD/USB-CDP/Wireless/USB 3.0/2.0 Max input current - For faster charging - Range: 100 - 3000/3500 mA (S8/S8+) -- Battery Informations -- Shows: -- accepted charging current -- input voltage -- battery temperature -- battery voltage -- Battery Care -- Stop charging at some lower level than 100 % to reduce battery aging - Range: 50 - 100 % -- Battery IDLE -- Power supply your phone over cable or wireless without to use the battery - Useful for DeX or gaming -- Set Max Charging Temperature - Range: 35 - 45 °C -- Battery Service -- Shows: -- charge cycles and ability to reset to 0 -- real battery capacity in %/mAh and ability to reset (battery gauge recalibration) -- Water Detection -- Ability to disable water detection -- Show water detection status # Screen -- Input Booster - Adjust touch boost CPU duration in ms - To improve scrolling # CPU -- Overclock Control -- BIG CPU: 741 - 2808 MHz* - default: 2314 MHz -- LITTLE CPU: 455 - 2002 MHz* - default: 1690 MHz -- Set Max Freq for screen OFF -- Ability to disable boost - For power save -- Governor up_threshold - To adjust balance between performance and power save -- BIG CPU DVFS Max Temp (thermal throttling)** - Range: 65 - 95 °C # GPU -- Overclock Control - 260 - 839 MHz* - default: 546 MHz -- Ability to disable boost - for power save -- Governor up_threshold - To adjust balance between performance and power save -- GPU DVFS Max Temp (thermal throttling)** - Range: 65 - 95 °C * Max stable Freq depends on the quality of the SoC ! ** To avoid too big performance drops from stock thermal throttling driver # Performance Profiles -- Power Save -- Balanced -- Performance (Kernel Default) -- Performance Plus (Gaming/OC) (Adjustable CPU/GPU Freq) # RAM -- Memory Management -- Low Memory Killer - Set the amount of min free RAM* - Range: 128 - 256 MB - Default: 192 MB -- Swap / zRam* - LZ4 compressed swap block-device in RAM - Choice: 0, 25, 50 or 75 % of RAM size -- Ability to drop caches / buffers - To free RAM * For multitasking, gaming, responsiveness and battery life # Network -- Adds kernel support for network file systems CIFS & NFS -- TCP Congestion Control - Choice: cubic, new reno, bic, westwood+, vegas, veno, hybla, etc.. -- Wi-Fi Band Selection - Choice: 2.4/5 GHz, 2.4 GHz only or 5 GHz only # Misc -- Torch - Set brightness for the highest level in Android quick settings - Range: 10 - 15 -- LED-RGB - Set blink ON/OFF delay for notifications / low battery -- Optimize RED, GREEN, BLUE LED - Increases brightness by disabling power save mode on low lux -- Accelerometer Calibration # Advanced Power Menu -- Reboot to: -- system -- recovery -- download -- or shutdown # Like this app ? - Please rate and leave a short comment. # # Privacy # -- In case the app crashes it will send only technical debug info to the play store server, for debugging. # CREDITS # -- World-gear-symbol by Freepik from www.flaticon.com - edited by ace2nutzer